N75C-1
Where to Buy
15 Degree Coil Sheathing and Siding Nailer
This 15-degree Coil Sheathing/Siding Nailer is ideal for high volume nailing. It is lightweight and quickly adjusts nail depth. Depend on this 15-degree Coil Sheathing/Siding Nailer for convenience and durability.
- specs:
-
Collation Type: Wire Weld Depth Adjustment: Yes Dry Fire Lockout: false Fastener Length: 1 1/2 - 3 in Fastener Type / Gauge:: 15 Degree Coil Siding Firing / Acutation Mode: Sequential with Contact Trigger Included Jam Clearance: Yes Magazine Angle: 15 Degree Magazine Capacity: 300 Magazine Loading: Bottom Load Nail Diameter: .090 - .131 in Operating Pressure: 70 -120 psi Power Source: Pneumatic Tool Height: 14.25 in Tool Length: 10.375 in Tool Weight: 4.9 lbs Tool Width: 4.875 in - Uses:
- Sheathing
- Siding
- Perfect for high-volume nailing of wall and roof sheathing
- Drives 15° wire weld collated and plastic inserted nails with shank diameters of .090" - .131"
- Lightweight aluminum design for durability
- Adjustable depth guide sets nails to desired depths quickly and conveniently
RECOMMENDED FASTENERS
-
15° Coil Framing Nails
Fastener DetailsSku Length Diameter Point Finish Quantity C12P120DG 3-1/4 .120 Diamond Point Thickcoat™ Galvanized 2700
-
The 15 Degree Coil Sheathing and Siding Nailer is covered by our 1-7 Year Limited Warranty
Warranty Details
Frequently Asked Questions
-
Do you have an MSDS for the Magnalube Teflon grease used in your Nailers?
This teflon grease is used in many of our nailers. Please check the attached list or your parts breakdown you can search here to assure yours is on it: -
How often should I oil my pneumatic tools? Can I add too much?
For the professional that uses the tools every day, the tool should have oil added daily. Just a drop or two a day will assure that the oil keeps the internal components moist and well lubricated.
Too much oil can cause some feeding problems due to the pooling of excess oil in air ports and chambers. This will create worse problems in cold weather because the oil will naturally thicken a bit, slowing the reaction of the moving parts. If you suspect that too much oil is in the tool, prop the tool up with the air fitting pointing downward and allow excess oil to drain into an oil pan. This is usually enough to allow the tool to cycle smoothly again. Avoid oiling for a few days when this action has been taken. Keep in mind that too much oil is far better than not enough. Dry tools can cause many malfunctions and can cause component damage.